>> about us    >> contact us     >> make enquiry     >> legal stuff ph   +61 (0)2 9683 5006
 
 
sil_pads
 
> Thermally Conductive
    Interface Materials
   • Introduction
   • Sil-Pads
   • Gap Pads
        - Gap Filling Materials
        - FAQs
   • Adhesive Tapes / Bond Ply
   • TIC - Thermal Interface       Compounds
   • High-Flow Phase Change       Interface Materials
         - Products
         - Comparison Data
   • Sil-Pad Selection Guide
   • Sil-Pad Configurations
   • Applications
 
 
> Thermal Clad  
> Touch Screens  
> Anti-Static Products
    ACL Staticide		  
 
 
Sil-Pad Materials  >> Thermally Conductive Insulators
 
  SIL-PAD Construction
Sil-Pads are constructed with a variety of different materials including fiberglass, silicone rubber, polyimide film, polyester film and fillers used to enhance performance. Sil-Pads are typically constructed with an elastomeric binder compounded with a thermally conductive filler coated on a carrier.
The characteristics of your application often determine which Sil-Pad construction will produce the best performance.
   
 
     
Sil-Pad 400
The Original Sil-Pad Material.
  Sil-Pad 800
High Performance Insulator for Low-Pressure Applications. 		 

Sil-Pad 900S
High Performance Insulator for Low-Pressure Applications.

   Sil-Pad 980
High Cut-Through Resistant, Electrically Insulating, Thermally Conductive Material
             
     
Sil-Pad 1100ST
Economical, Electrically Insulating, Thermally Conductive, Soft Tack Elastomeric Material.		   Sil-Pad A1500
Electrically Insulating, Thermally Conductive Elastomeric Material.		   Sil-Pad 1500ST
Electrically Insulating, Thermally Conductive, Soft-Tack Elastomeric Material		   Sil-Pad 2000 (10 mil)
The High Performance High Reliability Insulator.
             
     
Sil-Pad A2000 (15 mil)
High Performance High Reliability Insulator. 		  Sil-Pad K-4
The Original Kapton®-Based Insulator		   Sil-Pad K-6
The Medium Performance Kapton®-Based Insulator		   Sil-Pad K-10
The High Performance Kapton®-Based Insulator for Thermal Management of Electronics
             
     
Q-Pad II
Foil-Format Grease Replacement for Maximum Heat Transfer 		  Q-Pad 3
Glass-Reinforced Grease Replacement Thermal Interface 		  Poly-Pad 400
Poly-Pad 1000
Poly-Pad K-4
Poly-Pad K-10
Polyester Based Thermally Conductive 		  Sil-Pad Tube
Silicone-Based, Thermally Conductive Tubes
             
           
Sil-Pad Shield
Bonded Laminate of Sil-Pad with a Copper Shield		            
 
 
  Phone: +61 (0)2 9683 5006  
  All © Copyright TJK Technologies
Web Site: b.b.advertising		 About Us  I  Contact Us  I  Thermal Interface Materials  I  Thermal Clad  I  Touch Screens  I  ACL Staticide